Printing a cylindric body this happens

Suggestions, critiques

Printing a cylindric body this happens

Messagepar breckjensen » 11 Nov 2017, 11:16


I tried to print a cylindric body with PLA and Easywood.
When I turn on the retraction (3mm retraction Speed900) than there i a big blob on all layers.

When I turn off the retraction, than I have this "gap" on every layer.

On which Parameters of retraction should I concentrate to avoid the failure?

Which informations do you need also, to help me?


I didn't find the right solution from the Internet.


animated explainer
Messages: 172
Inscrit le: 27 Sep 2017, 08:42

Retour vers Apps

Qui est en ligne ?

Utilisateur(s) parcourant ce forum : Aucun utilisateur inscrit et 1 invité